Most of these cuts are done on dry hair with point cut ends, because a square jaw shows every blunt line once the hair falls. With hair for a square face shape, the goal is keeping the edge off the jaw, either at the lip line or past the collarbone, and letting layers or a fringe soften the corners.
1. Long Layers With a Side Part

Long layers with a side part are the hair for square face shape clients I start with, because the diagonal line softens the jaw. I cut the perimeter two inches below the collarbone on dry hair, then point cut layers from the chin down. It suits fine to thick density and 1A to 2B texture. Blow-dry with a round brush, part to one side, and finish with serum. Trim every eight weeks.
2. Collarbone Lob With Waves

A collarbone lob with waves puts movement right beside the jaw so the angle reads softer. I cut the perimeter at the collarbone on dry hair with point cut ends, then add one long layer at the chin. It suits fine to medium density and 1B to 2B texture on a square face. Wave with a one-inch iron, leaving the last inch straight, and break up with a light spray. Trim every eight weeks.
3. Curtain Bangs With Long Layers
Credit: Instagram
Curtain bangs break up the width of a square forehead and taper past the cheekbone instead of stopping at the jaw. I section a triangle, cut the bangs from the brow to the cheekbone, then point cut long layers from the collarbone. It suits fine to medium density and 1B to 2B texture. Blow-dry the bangs out with a small round brush. Trim the bangs every five weeks.
4. Short Hair for Square Face Shape With Soft Layers

Short hair for square face shape clients works when the perimeter sits above the jaw, not on it. I cut a bob at the lip line on dry hair with point cut ends, then point cut soft layers through the sides. It suits fine to medium density and 1B to 2B texture. Blow-dry with a round brush rolling under and a smoothing cream. Trim every six weeks.
5. Shoulder Length Shag

A shoulder length shag puts texture around the jaw so the corners read softer. I cut the perimeter at the shoulder on dry hair, point cut short crown layers, then razor the face frame from the cheekbone down. It suits medium to thick density and 1B to 2C texture on a square face. Rough-dry with a texture spray and scrunch the ends. Trim every eight weeks.
6. Side Swept Pixie

A side swept pixie leaves length through the top so a diagonal fringe crosses the forehead. I cut the sides and nape with scissor over comb on dry hair, leave the top four inches, then cut the fringe from the part to the cheekbone. It suits fine to medium density and 1A to 2A texture on a square face. Blow-dry the fringe across with a flat brush and set with a light paste. Trim every five weeks.
7. Hair for Square Face Shape Over 50
Credit: Instagram
The hair for square face shape over 50 I cut most is a shoulder length cut with long layers and a side fringe. I cut the perimeter at the shoulder on dry hair with point cut ends, point cut layers from the chin, then cut the fringe from the part to the cheekbone. It suits fine to medium density and 1A to 2A texture. Blow-dry with a round brush and a smoothing cream. Trim every eight weeks.
8. Wispy Fringe With Long Hair

A wispy fringe softens a square forehead where a blunt fringe would square it further. I cut the fringe at the brow on dry hair, point cut deep into it so it separates, then leave the length past the collarbone with long layers. It suits fine to medium density and 1A to 2A texture. Blow-dry the fringe down with a small brush and air-dry the rest. Trim the fringe every four weeks.
9. Chin Length Bob With Face Framing Layers

A bob that falls just past the chin clears the jaw, and face framing layers break the line beside it. I cut the perimeter an inch below the chin on dry hair with point cut ends, then point cut face framing pieces from the cheekbone. It suits fine to medium density and 1A to 2B texture on a square face. Blow-dry with a round brush and tuck one side. Trim every six weeks.
10. Short Hair for Square Face Shape With Curtain Bangs
Credit: Instagram
Short hair for square face shape clients with curtain bangs keeps the bob above the jaw and the bangs falling to the cheekbone. I cut the perimeter at the lip line on dry hair with point cut ends, section a triangle, then cut the bangs from the brow to the cheekbone. It suits fine to medium density and 1B to 2B texture. Blow-dry the bangs out with a small round brush. Trim the bangs every five weeks.
11. Beach Waves Past the Shoulder

Beach waves past the shoulder add width at the cheekbone so the jaw reads narrower by comparison. I cut the perimeter three inches below the collarbone on dry hair with point cut ends, then point cut long layers. It suits medium to thick density and 1B to 2C texture on a square face. Scrunch a sea salt spray into damp hair and air-dry, or wave with a one-inch iron. Trim every ten weeks.
12. Hair for Square Face Shape Over 60

For hair for square face shape over 60, I keep the perimeter at the chin with soft layers and a side swept fringe. I cut the perimeter an inch below the chin on dry hair with point cut ends, point cut layers from the cheekbone, then cut the fringe to the cheekbone. It suits fine to medium density and 1A to 2A texture. Blow-dry with a round brush and a smoothing cream. Trim every six weeks and gloss every eight.
13. Textured Crop With Long Fringe

A textured crop with a long fringe keeps the sides close and sends the weight forward across the forehead. I cut the sides with scissor over comb on dry hair, point cut the top to three inches, then leave the fringe to the brow and point cut it. It suits fine to medium density and 1B to 2B texture on a square face. Rough-dry with a texture paste and push the fringe to one side. Trim every five weeks.
14. Layered Lob With Side Part

A layered lob with a side part is the mid length cut for a square face that stays easy. I cut the perimeter at the collarbone on dry hair with point cut ends, point cut layers from the chin, then part on the heavier side. It suits fine to medium density and 1A to 2B texture. Blow-dry with a round brush rolling the ends under. Trim every eight weeks.
15. Short Hair for Square Face Shape With Waves

Short hair for square face shape clients with wave sits best at the lip line where the bend lands beside the cheekbone, not the jaw. I cut the perimeter at the lip on dry hair with point cut ends and leave the interior solid. It suits fine to medium density and 2A to 2C texture. Scrunch a sea salt spray into damp hair, part to one side, and air-dry. Trim every six weeks.
16. Long Hair With Face Framing Layers

Face framing layers that start at the cheekbone draw the eye off a square jaw. I cut the perimeter past the collarbone on dry hair with point cut ends, point cut the face frame from the cheekbone to the collarbone, then leave the back long. It suits fine to thick density and 1A to 2B texture. Blow-dry the face frame away from the face with a round brush. Trim every ten weeks.
17. Curly Shoulder Length Cut

A curly shoulder length cut gives a square face width at the cheekbone and softness at the jaw. I cut the perimeter at the shoulder curl by curl on dry hair, then cut layers from the chin so the curl stacks. It suits medium to thick density and 3A to 3C texture. Rake a curl cream through wet hair, diffuse on low, and sleep in a satin bonnet. Trim every ten weeks.
18. Side Part Pixie With Long Top

A pixie with a long top and a side part keeps the lift off center so the forehead reads less wide. I cut the sides and nape with scissor over comb on dry hair, leave the top five inches, then point cut it. It suits fine to medium density and 1A to 2A texture on a square face. Blow-dry the top to one side with a round brush and set with a light paste. Trim every five weeks.
19. Shoulder Length Cut With Curtain Bangs

Curtain bangs on a shoulder length cut frame a square face on both sides from the brow to the cheekbone. I cut the perimeter at the shoulder on dry hair with point cut ends, section a triangle, cut the bangs to the cheekbone, then point cut one layer at the chin. It suits fine to medium density and 1B to 2B texture. Blow-dry the bangs out with a small round brush. Trim the bangs every five weeks.
20. Razor Cut Lob

A razor cut lob leaves the ends soft so nothing sits in a hard line near the jaw. I cut the perimeter at the collarbone on dry hair, razor the last two inches, then razor face framing pieces from the cheekbone. It suits medium to thick density and 1B to 2B texture on a square face. Rough-dry with a light cream and leave the ends as they fall. Trim every eight weeks.
21. Short Hair for Square Face Shape With Side Swept Fringe

A side swept fringe is the short hair for square face shape detail I add most, because the diagonal cuts across the forehead. I cut a bob at the lip line on dry hair with point cut ends, then cut the fringe from the part to the cheekbone. It suits fine to medium density and 1A to 2A texture. Blow-dry the fringe across with a flat brush and the bob under. Trim every six weeks.
22. Long Hair With Balayage

Balayage on long hair for a square face puts the brightest pieces at the cheekbone and leaves depth at the jaw. I cut the perimeter past the collarbone on dry hair with point cut ends and long layers, then hand paint to a level nine from the cheekbone down. It suits fine to thick density and 1A to 2B texture. Blow-dry with a round brush and finish with serum. Refresh every twelve weeks.
23. Wolf Cut
Credit: Instagram
A wolf cut stacks short layers at the crown and lets the length fall past the shoulder, so the weight is away from the jaw. I cut the perimeter below the shoulder on dry hair, point cut short crown layers, then razor the face frame from the cheekbone. It suits medium to thick density and 1B to 2C texture on a square face. Rough-dry with a texture spray. Trim every eight weeks.
24. Angled Bob Past the Chin

An angled bob that lands past the chin in front puts a diagonal beside the jaw instead of a horizontal line. I cut the nape an inch shorter than the front on dry hair with point cut ends, keeping the front an inch below the chin. It suits fine to thick density and 1A to 2A texture on a square face. Blow-dry with a round brush rolling under. Trim every six weeks.
25. Soft Waves With Side Part Over 40

Soft waves with a side part on hair past the collarbone give a square face over 40 movement without a lot of effort in the morning. I cut the perimeter past the collarbone on dry hair with point cut ends and long layers. It suits fine to medium density and 1A to 2B texture. Wave with a one-and-a-quarter-inch iron, brush out, and finish with a light spray. Trim every ten weeks.
26. Copper Lob With Layers

Copper on a layered lob warms the face and keeps the eye on the color rather than the jaw. I cut the perimeter at the collarbone on dry hair with point cut ends, point cut layers from the chin, then apply a level seven copper. It suits fine to medium density and warm skin tones on a square face. Blow-dry with a round brush and finish with serum. Refresh the tone every five weeks.
27. Pixie With Longer Fringe to the Cheekbone

A long fringe to the cheekbone on a pixie gives a square face one soft piece against the forehead. I cut the sides and nape with scissor over comb on dry hair, leave the front long, then cut the fringe from the part to the cheekbone. It suits fine to medium density and 1A to 2A texture. Blow-dry the fringe across with a flat brush and set with paste. Trim every five weeks.
28. Dark Brunette Layers Past the Shoulder

Dark brunette on long layers keeps the shape soft and the line beside the jaw unbroken. I cut the perimeter past the shoulder on dry hair with point cut ends, point cut long layers from the chin, then apply a level four demi from root to end. It suits fine to thick density and cool or neutral skin tones on a square face. Blow-dry with a round brush and finish with serum. Refresh the tone every eight weeks.
29. Air Dry Lob With Side Part

The air-dry version of hair for square face shape clients is a lob at the collarbone with one layer and a side part. I cut the perimeter at the collarbone on dry hair with point cut ends, then point cut one layer at the chin. It suits fine to medium density and 1C to 2B texture. Apply a light cream to damp hair, part to one side, and leave it alone until dry. Trim every eight weeks.
30. Blonde Money Piece With Long Layers
Credit: Instagram
A money piece on long layers brightens the face frame so the jaw sits behind the light. I cut the perimeter past the collarbone on dry hair with point cut ends and long layers, then lighten the two front sections to a level nine and tone beige. It suits fine to medium density and 1A to 2B texture on a square face. Blow-dry the front out with a round brush. Refresh every ten weeks.
31. Low Maintenance Shoulder Length Cut

The low maintenance cut is shoulder length with long layers and a side part that air-dries. I cut the perimeter at the shoulder on dry hair with point cut ends, point cut layers from the chin, then texturize the ends. It suits fine to medium density and 1B to 2B texture on a square face. Apply a light cream to damp hair, part to one side, and leave it alone until dry. Trim every ten weeks.
Most of these cuts are done on dry hair with point cut ends, because a square jaw shows every blunt line once the hair falls, so the finish has to stay soft. Hair for a square face shape works best with a little length past the jaw and a side part that breaks up the forehead. A smoothing brush is the only tool it needs. oval face haircuts follow the same idea: work the perimeter and the crown before you touch the length.
